Plumbing runs are hidden in some of the strangest places. Often, you don’t know if a wall has plumbing until it is completely opened up. This can make detecting a leak very hard. Unfortunately, leaks have to be stopped quickly before the damage escalates into large repair bills. These are some of the ways that leaks are detected by a plumber.
One of the means of Leak Detection in Jackson Ms, is with a device that measures the moisture in the walls. A high level of moisture content signals the possibility of a leak. This helps the plumber to determine which area the leak is coming from. But, since water naturally runs downhill due to gravity, the moisture content measurement will give a general idea of where the leak is. Removal of the wall is necessary to pinpoint the leak.
Another means is to measure the temperature in the walls with a temperature measuring device. Since water has a cooling effect on items, a dramatic change in temperature from the top of the wall to the bottom of the wall can indicate that a leak is occurring in the wall. The place where the temperature changes is an indication of the approximate location of the leak. But, it is better suited to testing of interior walls than exterior walls because the outside weather conditions can affect readings.
One method of Leak Detection in Jackson Ms, is to run a thin camera down the piping and visually look at the piping to determine points of leakage. The plumber can also inspect the piping using this method. This is handy for piping that is buried deep in the earth, such as drainage piping that might be leaking beneath the basement floor.
These are some of the methods that a plumber can use to detect a possible leakage in the walls. Because much of the plumbing is hidden in walls and other areas, it can be impossible to spot a leak until the walls are opened up. By then, the damage has probably already been done. Detecting these leaks early is essential in preventing damage associated with leaks.
